Iron in its various forms is one of the most persistent and troublesome challenges in water treatment. It is sometimes simple, but it is often a complex issue that requires some trial and error in treatment.
Iron occurs naturally in three essential forms with some variations:
Ferrous Iron, also called clear water iron. This is actually ferrous bicarbonate. The water is clear when drawn but becomes cloudy when it comes in contact with air (or another oxidizer). When air oxidizes the ferrous iron, it becomes ferric iron.
Ferric Iron, or red water iron. Ferric iron is actually ferric hydroxide. Ferric iron is visible in water and gives it a rust color.
Heme Iron, or organic iron. Heme iron is organically bound iron combined with decomposed vegetation called tannins or lignins which give it a weak tea or coffee color.
Each of these can exist alone or in combination with other forms.
Another iron issue is so-called "colloidal iron," which refers to iron that exists in extremely small particles that do not clump together to make them filterable because of their electrical charge. Colloidal iron often appears as a persistent yellow/orange color that will not settle out of the water. Complete removal may require addition of an agent such as alum to cause clumping together of small particles to a filterable size. Often final filtration down to one micron is required.
Bacterial Iron. Certain bacteria feed on iron as an energy source. They oxidize the ferrous iron to its ferric state and deposit it in a slime gel with which they surround themselves. These bacteria grow in stringy clumps and are found in some but not all waters that bear ferrous iron.
There is no EPA establish MCL for iron and it is regarded as an aesthetic rather than a health issue. In general, if it is present at a level of 0.3 parts per million or more it will create problems with residential or industrial water.
Treatment. Removing iron from water.
Under the right conditions, ferrous iron can be removed by ion exchange (a water softener) or by oxidizing it to ferric iron then removing it with mechanical filtration. Ferrous iron "can be removed with a softener provided it is less that 0.5 ppm for each grain of hardness and the pH of the water is greater than 6.8." (The Enting Corporation Engineering Handbook. Not everyone would agree.) Generally, it is accepted that about 5 ppm fe is the upper limit for removal with a water softener. Ferrous iron is most commonly removed by oxidation (with air, ozone, potassium permanganate, chorine, or hydrogen peroxide) and filtration. This is a tricky process at times and different filter media are pH dependent at different levels. Some media (Filox, Birm, Greensand) can act as both oxidizer and filter if conditions (pH and dissolved oxygen, for example) are right.
Ferric iron is removed poorly by a water softener, but it can be removed readily by filtration--even with a simple wound string filter, although backwashing filters are most commonly used because iron stops up conventional sediment filters quickly unless the amount is very small.
Heme iron can be removed by a scavenger anion resin or by oxidation with chlorine followed by mechanical filtration.
When iron bacteria are present, the standard treatment is chlorination followed by filtration.
|Removing iron with aeration.